Toro Greensmaster eTriFlex 3360 Service Manual page 96

Installing the Engine (continued)
Engine (Model 04580): Service and Repairs
g286602
1. Engine
2. Engine pulley
The engine assembly weighs approximately 42 kg (92 lb). Use an
appropriate lift to install the engine assembly.
Make sure to not damage the engine, fuel or vent hoses, oil drain
hose, electrical harnesses, control cables or other parts while
installing the engine.
2. Secure the engine to the engine frame with the 4 cap screws previously
removed.
3. Secure the drip pan to the engine frame.
4. Fit the starter/generator drive belt over the engine pulley and adjust the drive
belt tension; refer to
(Model 04580) (page
5. If the engine was removed from the machine separately, proceed to step
7 of this procedure. If the entire engine frame assembly (including the
starter/generator) was removed:
Figure 18
3. Set screw (2 each)
4. Square key
CAUTION
IMPORTANT
Adjusting the Starter/Generator Drive Belt Tension
5–17).
Page 4–16 Greensmaster® eTriFlex 3360 and 3370
19239SL Rev A