Toro Greensmaster eTriFlex 3360 Service Manual page 285

Inspecting the Reel Assembly
Greensmaster® eTriFlex 3360 and 3370
19239SL Rev A
g227240
1. Cutting reel
2. Flocked seal (2 each)
3. Bearing (2 each)
4. Plug (2 each)
5. reel nut (right hand thread)
1. Remove the reel nuts from the cutting reel. Check the splines in the reel nuts
for excessive wear or distortion and replace them if necessary.
Note: Reels+™ is a line of replacement reels (with the seals and bearings
pre-assembled) that arrive ready for installation into the cutting unit. Contact
your local Toro Distributor for additional information.
2. Press the bearings and slide the seals from the reel shaft. Discard the seals
and inspect the reel bearings to insure that they spin freely and have a
minimal amount of axial play.
3. Inspect the reel:
A. Place the reel shaft ends in V-blocks and check the reel shaft for
distortion.
B. Check the threads in the ends of the reel shaft.
C. Check the reel blades for bending or cracking.
D. Check the service limit of the reel diameter; refer to
for Grinding (page
E. Replace the reel if damage is evident.
Figure 139
6. Reel nut (black – left hand thread)
7. Groove indication left hand threads
8. Left-most reel spider
9. Bearing shoulder
7–20).
Page 7–17
Preparing the Reel
DPA Cutting Units: Service and Repairs