Toro Greensmaster eTriFlex 3360 Service Manual page 63

Machine Faults (continued)
Fault
Fault Title
ID
P156C Traction
Controller
- Internal
Hardware
Failure
P156D Traction
Controller
- Internal
Software
Failure
P156E Traction Motor
Software -
Hardware
Incompatibility
P1B01 Starter/Generator
Motor - High
Temp Shutdown
P1B11 Starter/Generator
Controller -
High Temp
Shutdown
Greensmaster® eTriFlex 3360 and 3370
19239SL Rev A
Fault
Controller(s)
Condition/Circuit
Affected
Description
SC5, SC6 An internal
component of
the controller
fails in the
indicated
traction motor
controller.
SC5, SC6 An unexpected
software error
occurs in
the indicated
traction motor
controller.
SC5, SC6 The software is
not compatible
with the
hardware in
the indicated
traction motor
controller.
T6 The
starter/generator
motor
temperature is
greater than
130° C (266° F).
T6 The
starter/generator
controller
temperature is
greater than 100
°C (212 °F).
Additional Notes Service Actions
Traction is 1.
disabled.
2.
3.
Traction is 1.
disabled.
2.
3.
Traction is 1.
disabled.
2.
3.
PTO and 1.
starter/generator
is disabled.
Note: This fault
is not produced
by a bad sensor.
2.
3.
4.
PTO and 1.
starter/generator
is disabled.
Note: This fault
is not produced
by a bad sensor.
2.
3.
4.
Page 3–27 Troubleshooting: Universal Groomer Problems
Replace and program the traction
motor controller (contact an Authorized
Toro Distributor for assistance).
Cycle the key switch.
Use the InfoCenter to calibrate the
traction motor controller.
For SC5, calibrate the traction pedal
first, then the traction motors.
For SC6, calibrate the traction motors.
Replace and program the traction
motor controller (contact an Authorized
Toro Distributor for assistance).
Cycle the key switch.
Use the InfoCenter to calibrate the
traction motor controller.
For SC5, calibrate the traction pedal
first, then the traction motors.
For SC6, calibrate the traction motors.
Replace and program the traction
motor controller (contact an Authorized
Toro Distributor for assistance).
Cycle the key switch.
Use the InfoCenter to calibrate the
traction motor controller.
For SC5, calibrate the traction pedal
first, then the traction motors.
For SC6, calibrate the traction motors.
Clean the air intake screen on the
back of the starter/generator. Be sure
the starter/generator is pulling air
through the air intake by feeling with
your hand or by testing with a piece
of paper.
Let the machine cool.
Reduce the cutting loads by reducing
the reel speed or reducing mow speed.
Replace the starter/generator motor.
Clean the air intake screen on the
back of the starter/generator. Be sure
the starter/generator is pulling air
through the air intake by feeling with
your hand or by testing with a piece
of paper.
Let the machine cool.
Reduce the cutting loads by reducing
the reel speed or reducing mow speed.
Replace and program the
starter/generator controller (contact
an Authorized Toro Distributor for
assistance).
(Optional)