Toro Greensmaster eTriFlex 3360 Service Manual page 237

Servicing the Rear Wheel Hub (continued)
Greensmaster® eTriFlex 3360 and 3370
19239SL Rev A
g293603
1. Dust cap (outside of hub)
2. Grease fitting and passage
A. Press the old roller clutches from the hub.
B. Press one new roller clutch from the inside of the hub. The white roller
cage of the roller clutch must be toward the inside (lip seal) of the hub.
The roller clutch should rest just below the inner shoulder of the hub
and not block the grease passage.
C. Press two new roller clutches from the outside of the hub. The white roller
cage of each roller clutch must be toward the inside (lip seal) of the hub.
The roller clutches should rest just below the inner shoulder of the hub
and not block the grease passage.
D. Apply a thin layer of high temperature grease (Mobil XHP-222 or
equivalent) to the inside of each roller clutch.
4. Install the wave washer in the inner hub bore.
5. Apply a thin layer of high temperature grease (Mobil XHP-222 or equivalent)
to the thrust bearings and install the thrust bearings and thrust washers as
shown in Figure 107.
6. Install the inner lip seal in the inner hub bore. Apply a thin layer of grease
to the lip of the seal.
Figure 108
3. Lip seal (inside of hub)
4. Roller clutch – white roller cage
Page 6–17 Chassis: Service and Repairs