Toro Greensmaster eTriFlex 3360 Service Manual page 93

Removing the Engine (continued)
g286730
1. Engine frame assembly
2. Cap screw
3. Cap screw ( 2 each)
4. Isolating mount – rear
5. Lock nut (3 each)
Greensmaster® eTriFlex 3360 and 3370
19239SL Rev A
• The engine wire harness connector at the main wire harness (left side
of engine). Check the engine and the harness connector for damage or
corrosion and clean or repair as necessary.
• The wire harness ground at the engine (near front left engine mount).
7. Disconnect the choke cable from the engine.
8. Remove the clamp securing the engine oil drain hose to the right side battery
tray.
9. If the engine is being removed from the machine separately, proceed to
step10 of this procedure. If the entire engine frame assembly (including the
starter/generator) is being removed:
6. Cap screw
7. Clamp
8. Lock nut
9. Flange nut (4 each)
10. Wire harness connector
Figure 16
11.
12.
13.
14.
Page 4–13
Isolating mount – front (2 each)
Cap screw (4 each)
Flat washer (3 each)
Cap screw (2 each)
Engine (Model 04580): Service and Repairs