Connecting The Emulator To The Target; I960 ® Rm/Rn I/O Processor With Pc-1149.1/100F (Cable P/N As01090025-Ax) - Intel i960 Design Manual

Intel® i960® RM/RN I/O Processor
Debug Connector Recommendations
12.3.3

Connecting The Emulator To The Target

The emulation software uses the first Test Access Port (TAP) on the PC-1149.1/100F
boundary-scan controller card to control the i960 RM/RN I/O processor. A cable should be
connected from the boundary-scan controller to the i960 RM/RN I/O processor target debug
interface connector as shown in the following tables. A cable built to one of the following
specifications is supplied with the corresponding emulator.
®
Table 12-18. i960 RM/RN I/O Processor with PC-1149.1/100F (cable P/N AS01090025-Ax)
PC-1149.1/100F Signal
TCK12 (see note)
SENSE#
T_OFF# (see note)
NOTE: Connected to target through 33
50
PC-1149.1/100F Pin
Name
TRST#
GND
TDO12
GND
TDI12
GND
TMS1
GND
GND
TMS3
GND
GND
GND
Target Signal Name
1 TRST#
2
3
4
5
6
7
8
9
10
LCDINIT#/
*
25
RSTIN#
12
I_RST/
13
RSTOUT#
14
11 PWRVLD
16
Ω
series resistor.
Target Debug Header
Pin
1
GND 2
TDI 3
GND 4
TDO 5
GND 6
TMS 7
GND 8
TCK 9
GND 10
11
GND 12
13
GND 14
15
GND 16
Design Guide