Adjusting The Volume - RADVision Scopia XT4000 Series User Manual

The system sends a pre-defined image to the remote endpoint, indicated by the
your display.
You can configure your Scopia XT Series to block video input from your local endpoint by
default at the start of each call. For more information see
on page

Adjusting the Volume

Press
call and during a videoconference.
To change the default speaker volume, perform the procedure in this section. This can be
done from the endpoint itself or from the Scopia XT Series web interface.
Procedure
Step 1
RADVISION | User Guide for Scopia XT4000 Series Version 3.1.1
64.
+ or - on the XT Remote Control Unit to adjust the sound you hear when receiving a
Access the volume settings, as follows:
•
From the endpoint's main menu, select Configure > Calling from the Main menu.
•
From the XT Series web interface, select Basic Settings > Call-Answer mode > General.
Figure 3-20 In-call menu
"Blocking Video Input by Default"
Making Point-to-Point Video Calls | 54
icon on