IO-Link Master with PROFINET Interface StandardLine 8 Ports IP 65 / IP 66 / IP 67
8
Set-up
Content
Read device and diagnostic information ................................................................................................22
When the supply voltage has been switched on, the AL1102 starts with the factory settings. The
display elements signal the current operating status (→
To enable parameter setting of the AL1102, the fieldbusinterface of the network environment must be
configured correspondingly.
► Configure the fieldbus interface (ports X21 / X22) (→
(→ S. 27) or →
Integrate the IO-Link master in the project
>
The fieldbus interface has valid IP settings.
>
The user can set the parameters of the AL1102.
Further steps:
Optional: Update the firmware of the AL1102 (→
Set the parameters of the AL1102 (→
Operating and display elements
Fieldbus: Set PROFINET interface
Firmware update
Configuration
(→ S. 23)).
(→ S. 35)).
(→ S. 41)).
52476
(→ S. 18)).
21
Need help?
Do you have a question about the IO-Link master-PROFINET AL1102 and is the answer not in the manual?