IO-Link Master with PROFINET Interface StandardLine 8 Ports IP 65 / IP 66 / IP 67
>
10.3
Replace IO-Link device
To replace an IO-Link device:
Requirement:
>
IO-Link device is with factory settings.
>
IO-Link device supports IO-Link standard 1.1 or higher.
1
Set data storage
► Set the following parameters of the IO-Link port:
Validation and Data Storage = [Type compatible V1.1 device with Restore]
► Save changes.
2
Replace IO-Link device
► Disconnect old IO-Link device from IO-Link master.
► Connect new IO-Link device with the same IO-Link port of the AL1102.
>
IO-Link master copies parameter values from the data memory to the new IO-Link device.
42
34182
Need help?
Do you have a question about the IO-Link master-PROFINET AL1102 and is the answer not in the manual?