Table of Contents
Advertisement
The trap-target command is used to add or remove a trap receiver from an snmp-trap-group. The
operational parameters specified in the command include:
A single snmp-trap-group log-id can have multiple trap receivers. Each trap receiver can have
different operational parameters.
An address can be configured as a trap receiver more than once as long as a different port is used for
each instance.
To prevent resource limitations, only configure a maximum of 10 trap receivers.
The no form of the command removes the SNMP trap receiver from the SNMP trap group.
Default
No SNMP trap targets are defined.
Parameters
name — specifies the name of the trap target, up to 28 characters in length
ip-address — the IP address of the trap receiver. Only one IP address destination can be specified
port — the destination UDP port used for sending traps to the destination, expressed as a decimal
snmpv1 | snmpv2c | snmpv3 — specifies the SNMP version format to use for traps sent to the
7705 SAR OS System Management Guide
•
the IP address of the trap receiver
•
the UDP port used to send the SNMP trap
•
SNMP version
•
SNMP community name for SNMPv1 and SNMPv2c receivers
•
security name and level for SNMPv3 trap receivers
Note: If the same trap-target name port port parameter value is specified in more than one
SNMP trap group, each trap destination should be configured with a different notify-
community value. This allows a trap receiving an application, such as NMS, to reconcile a
separate event sequence number stream for each 7705 SAR event log when multiple event
logs are directed to the same IP address and port destination.
per trap destination group.
Values
ipv4-address a.b.c.d (host bits must be 0)
ipv6-address x:x:x:x:x:x:x:x (eight 16-bit pieces)
integer. Only one port can be specified per trap-target statement. If multiple traps need to be
issued to the same address, multiple ports must be configured.
Values
1 to 65535
Default
162
trap receiver
x:x:x:x:x:x:d.d.d.d
x: [0 to FFFF]H
d: [0 to 255]D
Event and Accounting Logs
289
Advertisement
Table of Contents
