Table of Contents
Advertisement
Security Command Reference
Global Password Commands
enable-admin
Syntax
enable-admin
Context
<global>
Description
The enable-admin command is in the default profile. By default, all users are given access to this
command.
Once the enable-admin command is entered, the user is prompted for a password. If the password
matches, the user is given unrestricted access to all the commands.
There are two ways to verify that a user is in the enable-admin mode:
A:ALU-1# show users
===============================================================================
User
===============================================================================
admin
admin
-------------------------------------------------------------------------------
Number of users : 2
'A' indicates user is in admin mode
===============================================================================
A:ALU-1#
A:ALU-1# enable-admin
MINOR: CLI Already in admin mode.
A:ALU-1#
104
Note: See the description for the
configured in the config>system>security>password context, then any user can enter
the special administrative mode by entering the enable-admin command.
•
enter the show users command — the Administrator can see which users are in this mode
•
enter the enable-admin command again at the root prompt and an error message will be
returned
Type
From
Console
--
Telnet
10.20.30.93
admin-password
Login time
10AUG2006 13:55:24
09AUG2006 08:35:23
7705 SAR OS System Management Guide
command. If the admin-password is
Idle time
0d 19:42:22
0d 00:00:00 A
Advertisement
Table of Contents
