Table of Contents
Advertisement
Log Command Reference
Parameters
application-id — the application whose events are affected by this event control filter
event-name | event-number — to generate, suppress, or revert to default for a single event, enter
generate — specifies that logger event is created when this event occurs. The generate keyword
severity-level — An ASCII string representing the severity level to associate with the specified
throttle — specifies whether events of this type will be throttled
suppress — indicates that the specified events will not be logged. If the suppress keyword is not
264
Values
A valid application name. To display a list of valid application
names, use the
aps, atm, bgp, chassis, debug, dhcp, dot1ag, efm_oam, eth-cfm,
filter, ip, isis, ldp, logger, mpls, ntp, oam, ospf, port, ppp, ptp, qos,
rip, route_policy, rsvp, security, snmp, stp, svcmgr, system, user,
vrtr
Default
none; this parameter must be explicitly specified
the specific number or event short name. If no event number or name is specified, the
command applies to all events in the application. To display a list of all event short names use
the show>log>event-control command.
Values
a valid event name or event number
Default
n/a
can be used with two optional parameters, severity-level and throttle.
Default
generate
generated events
Values
one of: cleared, indeterminate, critical, major, minor, warning
Default
the system-assigned severity level
Default
By default, event throttling is off for each specific event type. It
must be explicitly enabled for each event type where throttling is
desired. This makes backwards compatibility easier to manage.
specified, then the events are generated by default.
Default
generate
applications
command. Valid applications are:
7705 SAR OS System Management Guide
Advertisement
Table of Contents
