Table of Contents
Advertisement
Log Command Reference
SNMP Trap Groups Commands
snmp-trap-group
Syntax
[no] snmp-trap-group log-id
Context
config>log
Description
This command creates the context to configure a group of SNMP trap receivers and their operational
parameters for a given log-id.
A trap group specifies the types of SNMP traps and specifies the log ID that will receive the group of
SNMP traps. A trap group must be configured in order for SNMP traps to be sent.
To suppress the generation of all alarms and traps, see the
and traps that are sent to this log-id, see the
are generated, they can be directed to one or more SNMP trap groups. Logger events that can be
forwarded as SNMP traps are always defined on the main event source.
The no form of the command deletes the SNMP trap group.
Default
There are no default SNMP trap groups.
Parameters
log-id — the log ID value of a log configured in the
trap-target
Syntax
trap-target name [address ip-address] [port port] [snmpv1 | snmpv2c | snmpv3]
notify-community {communityName | snmpv3SecurityName} [security-level
{no-auth-no-privacy | auth-no-privacy | privacy}] no trap-target name
Context
config>log>snmp-trap-group
Description
This command adds or modifies a trap receiver and configures the operational parameters for the trap
receiver.
Before an SNMP trap can be issued to a trap receiver, the
trap-target must be configured.
288
sent to the trap receivers until a valid log-id exists.
Values
1 to 99
event-control
filter
(log destination) command. Once alarms and traps
to snmp
context. Alarms and traps cannot be
to
console, snmp-trap-group, and at least one
7705 SAR OS System Management Guide
command. To suppress alarms
Advertisement
Table of Contents
