Signal On Alarm - Endress+Hauser Proline Promass E 100 Manual

Signal on alarm

10
Заказывайте на сайте: www.tinnova.ru/endress_hauser/ || Эл. почта: info@tinnova.ru
Assignable measured • Mass flow
variables • Volume flow
• Corrected volume flow
• Density
• Reference density
• Temperature

Switch output
Switching behavior Binary, conductive or non-conductive
Switching delay Adjustable: 0 to 100 s
Number of switching Unlimited
cycles
Assignable functions • Off
• On
• Diagnostic behavior
• Limit value
• Flow direction monitoring
• Status

PROFIBUS DP
Signal encoding NRZ code
Data transfer 9.6 kBaud...12 MBaud
Modbus RS485
Physical interface In accordance with EIA/TIA-485-A standard
Terminating resistor • For device version used in non-hazardous areas or Zone 2/Div. 2: integrated
• For device version used in intrinsically safe areas: integrated and can be
EtherNet/IP
Standards In accordance with IEEE 802.3
PROFINET
Standards In accordance with IEEE 802.3
Depending on the interface, failure information is displayed as follows:
The range of options increases if the measuring device has one or more
application packages.
– Mass flow
– Volume flow
– Corrected volume flow
– Density
– Reference density
– Temperature
– Totalizer 1-3
– Partially filled pipe detection
– Low flow cut off
The range of options increases if the measuring device has one or more
application packages.
and can be activated via DIP switches on the transmitter electronics module
activated via DIP switches on the Safety Barrier Promass 100
Proline Promass E 100
Endress+Hauser