Renesas R8C/Tiny Series Software Manual page 55

Chapter 3 Functions
(4) Operation
Explains the operation of the instruction using symbols.
(5) Function
Explains the function of the instruction and precautions to be taken when using the instruction.
(6) Selectable src / dest (label)
If the instruction has operands, the valid formats are listed here.
R0L/R0 R0H/R1
A0/A0 A1/A1
dsp:8[A0] dsp:8[A1]
dsp:16[A0] dsp:16[A1]
dsp:20[A0] dsp:20[A1]
R2R0 R3R1
(a) Items that can be selected as src (source)
(b) Items that can be selected as dest (destination)
(c) Addressing modes that can be selected
(d) Addressing modes that cannot be selected
(e) Shown on the left side of the slash (R0H) is the addressing mode when data is handled in bytes (8 bits).
Shown on the right side of the slash (R1) is the addressing mode when data is handled in words (16 bits).
(7) Flag change
Shows a flag change that occurs after the instruction is executed. The symbols in the table mean the
following.
" " The flag does not change.
—
"O" The flag changes depending on a condition.
(8) Description example
Description examples for the instruction.
(9) Related instructions
Related instructions that cause an operation similar or opposite to that of the instruction.
Rev.2.00 Oct 17, 2005
REJ09B0001-0200
src
R1L/R2 R1H/R3
[A0] [A1]
dsp:8[SB] dsp:8[FB] dsp:8[A0]
dsp:16[SB] abs16
abs20 #IMM
A1A0 dsp:8[SP]
page 37 of 263
dest
R0L/R0 R0H/R1
A0/A0 A1/A1
dsp:8[A1]
dsp:16[A0] dsp:16[A1] dsp:16[SB] abs16
dsp:20[A0] dsp:20[A1] abs20
R2R0 R3R1
3.1 Guide to This Chapter
R1L/R2 R1H/R3
[A0] [A1]
dsp:8[SB] dsp:8[FB]
A1A0 dsp:8[SP]
(a)
(b)
(c)
(d)
(e)