Electrical Connection Of Ultraflow ® And Multical; Electrical Connection Of Pulse Transmitter And Pulse Divider - Kamstrup ULTRAFLOW 54 Technical Description

TECHNICAL DESCRIPTION
7.6 Electrical connection of ULTRAFLOW
Please note that using long signal cables requires careful consideration in connection with installation. There
must be a distance of min. 25 cm between signal cables and all other cables to prevent electrical disturbance.

7.7 Electrical connection of Pulse Transmitter and Pulse Divider

®
If ULTRAFLOW and MULTICAL
®
MULTICAL .
Note: Flow-info is not possible if Pulse Transmitter is used.
®
If ULTRAFLOW is connected to other equipment than MULTICAL
Transmitter or Pulse Divider.
ULTRAFLOW
Blue (ground)
Red (supply)
Yellow (signal)
Table 17. Connecting ULTRAFLOW
Diagram 2. Three-wire connection of Pulse Transmitter with output module (Y=2)
28
®
ULTRAFLOW
Blue (ground)
Red (supply)
Yellow (signal)
Table 16. Connecting ULTRAFLOW
®
are connected via a Pulse Transmitter, ULTRAFLOW
Pulse Transmitter/
®
→ → → →
Pulse Divider
Input
11
→ → → →
9
→ → → →
10
→ → → →
®
and MULTICAL
*) Pulse Divider is not normally used together with MULTICAL
®
to MULTICAL 602/801. Cable length up to 25 metres.
5512-385 GB/02.2014/Rev. H1
ULTRAFLOW
®
and MULTICAL
®
MULTICAL
→ → → →
11
→ → → →
9
→ → → →
10
→ → → →
®
and MULTICAL
®
, always connect ULTRAFLOW
→ → → →
*)
Output
11A
→ → → →
9A
→ → → →
10A
→ → → →
®
via Pulse Transmitter/Pulse Divider.
®
54 and 34
®
®
.
®
is galvanically separated from
®
via Pulse
®
MULTICAL
11
9
10
®
.