Change Of Location; Transport, Storage And Operating Conditions; Function Notes - BOCK belluno Assembly And Operation Manual

4.6

Change of location

If the bed must be moved to another location, please follow these safety instructions:
– Bring the lying surface to the lowest position.
– Before proceeding, pull out the mains plug and attach with the suspension device
at the side rail, to secure the power cable against falling and being crushed
through over-travel. Make sure that the cable is not dragged over the floor.
– Before inserted the mains plug again, inspect the power cable visually for me-
chanical damage (dents and kinks, abrasions and bare wires).
– Place the power cable in a way that it will not be rolled over or strained during
the operation of the bed or could be damaged when inserting the mains plug
again.
4.7

Transport, storage and operating conditions

Temperature
Relative humidity
Air pressure
4.8

Function notes

To fix the bed in place, the brakes on the castors (if any) of the
chassis must be locked. To accomplish this, use your foot to
move the locking lever on the chassis downwards.
If necessary, pull the integrated side rails up until they lock
into place. When using mattresses of different thickness, the
minimum height of 22 cm, measured from the top edge of the
side rail above the mattress without compression, may not be
underrun (additionally, a third attachment guard must be used).
Transport and storage
0°C to +40°C
20% to 80%
800hPa to 1060hPA
40
Operation
10°C to +40°C
20% to 70%