Caution: Electric Drive - BOCK belluno Assembly And Operation Manual

3.2

Caution: Electric drive

The electrically operated nursing care bed enables the person in need of care to support
the recovery process psychologically and physically and at the same time relieve pain
through its various functions. Electrically operated beds that are medical products need
special care in regards to constant safety checks. This includes safety-conscious handling
of the bed, daily inspection of electrical equipment and proper maintenance and clean-
ing.
To prevent damages to the cables, wiring should be conducted outside of the area in
which damages could be caused. Furthermore, avoid touching the sharp parts. To prevent
injury through an electric shock, avoid the possibilities of too high contact voltages. These
circumstances may especially be the case if the power cable is damaged, if inadmissible
and excessive leakage currents exist, or if liquid was spilled into the motor housing, e.g.
during improper cleaning. This damage can cause malfunction of the control, which could
result in unwanted movements of single bed elements, posing a risk of injury for the op-
erator and the person in need of care.
All drive components must not be opened!
Troubleshooting or exchanging single electrical components may be performed only by special
qualified personnel.
The motors meet the water protection standard IPX4. Do not squeeze/crush the cables. Adjust-
ment of moving parts may only be used for the intended use. Hermann Bock GmbH assumes no
liability for unauthorized technical changes.
Do not try to fix failures on the electrical equipment by yourself. It could be fatal! Either call the
customer service of Hermann Bock GmbH or an authorised/licensed electrician who conducts
the troubleshooting in compliance with all relevant VDE regulations and safety regulations.
Hazard note by Bock
Hazard note by Bock
Hazard note by Bock
18