BOCK belluno Assembly And Operation Manual page 27

The power cable must be screwed to the lug of the lying surface with the strain relief
provided on the cable. Connect the mains plug. Connect the hoist motor to the lying sur-
face motor.
Push one end piece on one side completely. The release button must snap into the hole
in the lying surface. Push on the second end piece only up to directly in front of the release
button.
Then hook the side rails into the pre-assembled
metal guides and arrange them.
Absolutely MAKE SURE to read the labels attached
on the top and bottom of the side rails so these may
not be mixed up with each other.
Press down on the release button and push in the
second end piece until it engages firmly in the hole
provided for it.
After assembly or before putting the bed into operation, move the adjustment range of
the lying surface over the control unit to check the optimum positioning of the cables. The
adjustment range must be passable without obstacles. The power cable must be routed
outside the bed and the hand control must be exposed.
27