Table of Contents
Advertisement
8.3.3.2. Partition 1 / 2
The parameter allows assigning particular monitoring partitions to outputs.
8.3.3.3. Activation time
The parameter defines the time the output is to be active.
8.3.3.4. Bistable
The parameter allows set bistable mode of the output. In this mode, the output will
be switched on for the duration of the state specified in the "Output Type".
If you set the output type as "unused", the output state can be changed only with
remote command.
8.3.4.
Emergency buttons
8.3.4.1. Icons
symbols match the
function keys on the keypad. The
"On" checkbox has to be checked in orded to enable the function key support.
CPX200NB ALARM CONTROL UNIT – INSTALLER MANUAL
69 / 116
Advertisement
Table of Contents
