Table of Contents
Advertisement
Installer can configure the text messages using following commands:
Command syntax
Command description
Feedback message
Feedback message
description
Command syntax
Command description
Feedback message
Feedback message
description
CPX200NB ALARM CONTROL UNIT – INSTALLER MANUAL
Acquiring the state of partitions
XXXX GETARMED
Acquiring the information which partitions are
armed/disarmed
XXXX – user code
Example: 1234 GETARMED
PARTITION1:X, PARTITION2:Y
or
GETARMED:ERROR
PARTITION1:X, PARTITION2:Y - Information about
partitions arm/disarm state.
PARTITION1,PARTITION2 – default partitions names,
they can be changed with the SETNAME command
X,Y – partition states, possibile values:
0 – disarmed
1 – armed
GETARMED:ERROR – command rejected by the
system
Setting the name of partition
XXXX SETNAME=PARTITION,NR,VALUE
Acquiring the information which partitions are
armed/disarmed
XXXX – user code
NR – number of the partition, possibile values: 1 or 2
VALUE – new name of the partition
Example 1:
1234 SETNAME=PARTITION,1,Cellar
Example 2:
1234 SETNAME="PARTITION,2,Kids Room"
SETNAME::OK or SETNAME:ERROR
SETNAME::OK – command accepted
SETNAME:ERROR – command rejected by the system
39 / 116
Advertisement
Table of Contents
