Table of Contents
Advertisement
6.1. ACTIVATION OF SERVICE MODE
To activate the service mode the installer code authorization is required.
3 beeps will confirm the correct input of the code and function number. PROG LED on will
inform that currently, the user is in service mode. When any service function is entered,
PROG LED will be blinking. After exit from the function, PROG LED will be lit constantly
again, informing that the user is in the main service mode menu.
6.2. EXIT FROM SERVICE MODE
To exit the service mode press
the control unit's reset using configured parameters.
The device will exit test mode automatically after 5 minutes without pressing the buttons
and system will restart.
6.3. INSTALLER CODE
The installer code can be changed here. 3 beeps will confirm the successfully entered
function.
where:
Installer code –
You can press
6.4. POWER LOSS
The function determines time in seconds after which failure is to be reported. The function's
argument is of decimal type. 3 beeps will confirm the successfully entered function.
To change /configure the time:
where:
Time –
time in seconds
You can press
6.5. RESET TO DEFAULT SETTINGS
That function resets the settings to their default configuration, accessible from the service
mode level. Additionally, the function sets the default output options and default installer
code.
CPX200NB ALARM CONTROL UNIT – INSTALLER MANUAL
and confirm with
<Installer code>
new installer code (from 4 to 7 digits)
any time to exit without saving changes.
any time to exit without saving changes.
<Installer code>
<Installer code>
<Time>
. Using that function will trigger
30 / 116
Advertisement
Table of Contents
