Table of Contents
Advertisement
7. CONFIGURATION WIZARD
7.1. PRELIMINARY NOTES
The configuration wizard of GPRS transmitters can be downloaded from www.ebs.pl
(login: ebs, password: ebs). Activate the option of installation wizard which leads through
the program installation process. By default it will be installed in C:\Program Files\EBS\
directory. The installation wizard can also create shortcuts to the program on the desktop
and in the Windows menu.
If it is the first use of the equipment, SIM card shall not be inserted into the slot until the
equipment is programmed using the above software. Otherwise, SIM card can be blocked
during the attempts of giving an incorrect PIN code. Alternatively, you can use SIM card
with PIN code authorization deactivated.
In case of remote programming, SIM card must be inserted before the configuration settings
transmission is initiated. In this case use either SIM cards with PIN code authorization
deactivated or change the PIN code using a mobile phone before the card is inserted into
the equipment.
7.2. COMPUTER – REQUIREMENTS
The minimum requirements for PC computer on which the configuration wizard is to be
installed are the following:
Hardware:
Processor 1GHz, 32-bit (x86) or 64-bit (x64)
1 GB RAM (for 32-bit) or 2 GB RAM (for 64-bit)
4,5 GB HDD,
Software:
Operating system: Windows 7 or newer
.NET Framework 4.5 software or newer.
7.3. PROGRAM FUNCTIONS
After the program is installed and started, the main window will be displayed on the screen.
From that level you can access both, program functions and programmable parameters (see
chapter 7).
The main program window was divided into a few areas.
Main menu: located in the top section of the window, contains control and program
configuration functions.
The main menu is composed of the following:
CPX200NB ALARM CONTROL UNIT – INSTALLER MANUAL
47 / 116
Advertisement
Table of Contents
