Table of Contents
Advertisement
8.1.5.2. Installer's code
Installer's code is used for equipment programming process using KP16 keypad.
Default factory setting is 2222. It should be changed at first equipment start-up
(programming). The code can be composed of from four to seven digits.
Installer's code could be read and change remotely via OSM.Server Console or by
sending SMS message. In case of reading Installer's code via OSM.Server Console,
please send following Custorm command:
GETPARAM=3,1
The answer with current Installer's code appears in the bottom part of the Console
window.
Installer's code could be changed via OSM.Server Console. In such case, please send
following Custom command:
SETPARAM=3,1,new_code
where new_code should contain from 4 up to 7 digits.
8.1.5.3. SIM Card PIN code
Since the equipment uses GSM network for its operation, it is necessary to obtain a
SIM card from a mobile network operator. You have to set a PIN code of a SIM card
dedicated for operation in particular equipment before its first use. It is necessary for
automatic start up of the system. In case you have a card without the PIN code, you
can enter any value in that box, e.g. 0000.
If you enter incorrect PIN code, the system will not start after inserting the card and
switching the power supply on and you will not be able to use the card until you
enter the PUK code (using any GSM phone).
Default factory PIN code entered in the equipment is: 1111.
CPX200NB ALARM CONTROL UNIT – INSTALLER MANUAL
60 / 116
Advertisement
Table of Contents
