Measured Value Display - Siemens FIDAMAT 6 Operating Instructions Manual

5.2

Measured value display

In the following, the displays below are referred to as the "Measured value display" which
appear in the display in the two operating states "Coded display mode" and "Decoded
display mode".
Note
Device operating state
In the "Measured value display", the current operating state of the device can be read in the
bottom line. The "Measured value display" is not an operating state and not an operating
mode, but is simply displayed. It must not be confused with the "Measure" operating state
(also "Measuring state") of the device!
Entering the main menu
Figure 5-3
On the right side of the measured value display is the measured component with an arrow
pointing to the right (►). A softkey is assigned to this component.
Press this softkey to call the main menu.
See also
General information about operation (Page 53)
FIDAMAT 6
Operating Instructions, 03/2018, A5E00222135-03
Measured value display
Operation
5.2 Measured value display
57