Siemens FIDAMAT 6 Operating Instructions Manual page 101

Select softkey 2. The following function screen appears on the display.
Figure 6-43
Here you assign one of the control functions listed below to each input as you like, whereby
every function may only be assigned once.
The connection assignments for the individual inputs can be found in the section "Electrical
connection".
No binary input has been preassigned in the factory.
Press the fifth softkey ("...cont."), to access the next function screen, thus branching to
further binary inputs.
Note
Save changes
Make sure you save every change in the configuration of the binary inputs in the user data
memory using function 75! If you neglect to do this, there is a danger that a previous
(unwanted) configuration will be loaded by "Load user data" (function 75).
FIDAMAT 6
Operating Instructions, 03/2018, A5E00222135-03
Defining binary inputs
Functions
6.6 Configuration
99