Siemens FIDAMAT 6 Operating Instructions Manual page 57

Device operating modes
Table 5- 2
Mode
Coded display mode
Decoded display mode
Operator control mode
FIDAMAT 6
Operating Instructions, 03/2018, A5E00222135-03
Operating modes of the FIDAMAT 6
Properties
Measured value display is shown
•
Protected submenus can only be
•
reached by entering a code
The current operating state of the
•
device (except for "Measuring") is
displayed in the bottom line
Function control not active
•
Measured value display is shown
•
The submenus protected by the
•
entered code are accessible
The current operating state of the
•
device (except for "Measuring") is
displayed in the bottom line
Function control active
•
Measured value can be influenced
•
Menu or function is displayed
•
Settings and inputs can be made
•
Function control active
•
Measured value can be influenced
•
5.1 General information about operation
Remarks
The device only supplies relia-
ble measured values in this
mode, provided it is in "Measur-
ing" operating state. You reach
this mode from operator control
mode by pressing the [MEAS]
key twice.
You reach this mode from oper-
ator control mode by pressing
the [MEAS] key once and con-
firming or discarding the entries
that were made.
You reach this mode from
"Coded display mode" by enter-
ing the code of the correspond-
ing operation level.
You configure/calibrate the
device in this mode.
Operation
55