Connecting The Safety Function Device - YASKAWA SERVOPACK Sigma 7W Series Product Manual

5.6 Connecting the Safety Function Device

5.6

Connecting the Safety Function Device

This section describes how to connect the SERVOPACK to a safety function device.
1.
Use a pair of pliers or a similar tool to remove the Safety Jumper Connector from the
connector for the safety function device (CN8).
2.
Connect the safety function device to the connector for the safety function device
(CN8).
Note: If you do not connect a safety function device, leave the Safety Jumper Connector connected to the connec-
tor for the safety function device (CN8). If the SERVOPACK is used without the Safety Jumper Connector
connected to CN8, no current will be supplied to the Servomotor and no motor torque will be output. In this
case, Hbb will be displayed on the Digital Operator or SigmaWin+.
5-16