Frt (Fault Ride Through) - Delta RPI M50A_120 Installation And Operation Manual

8.18 FRT (Fault Ride Through)

Overview
Values have been set based upon country standards. If you modify these values, you will lose certi-
fi cation. Therefore you should set this function only when requested by country regulations, authori-
ties or your grid operator.
With this function you can set the operation behavior of the inverter for FRT (Fault Ride Through).
t1 : The point in time when the fault occurs.
Accessing the menu
Main menu > FRT
1 0 . S e p 2 0 1 4 1 5 : 3 2
S t a t u s : O n G r i d
P o w e r :
E - T o d a y :
I n v e r t e r I n f o .
G e n e r a l S e t t i n g s
I n s t a l l S e t t i n g s
A c t i v e / R e a c t i v e P w r
F R T
Do not change this setting without prior
consultation with Delta Solar Support.
Installation and Operation Manual for RPI M50A Installation and Operation Manual for RPI M50A
Fig. 8.28: Operation behavior for FRT (Fault Ride Through)
1.
When the default information is displayed, press any button to open the
main menu. Otherwise, repeatedly press the button
0 W
menu is displayed.
0 k W h
2.
Use the buttons
To confi rm your selection, press the button
3.
The menu is protected by password 5555. Use the buttons
to set each digit.
To confi rm a digit, press the button
and to select FRT.
ENT
.
ENT
8 Settings
until the main
ESC
.
and
83 83