Delta RPI M50A_120 Installation And Operation Manual page 77

M o d e :
Q u p p e r : I n d 1 . 0 0
P l o w e r :
Q l o w e r : I n d 1 . 0 0
M o d e :
Q u p p e r : I n d 1 . 0 0
P l o w e r :
Q l o w e r : I n d 1 . 0 0
Confi gurable Parameters
Parameter
Mode
Q upper
P upper
Q lower
P lower
V lock-in
V lock-out
Do not change this setting without prior
consultation with Delta Solar Support.
Installation and Operation Manual for RPI M50A Installation and Operation Manual for RPI M50A
6.
O N
To change the mode, use the buttons
press the button
4 5 %
To switch the function on, select ON and press the button
To switch the function off, select OFF and press the button
you switch the function off, you can ignore the following steps.
O N 7.
If you need to change a parameter, use the buttons
select the parameter and press the button
4 5 %
8.
To change the parameter value, use the buttons
To confi rm your setting, press the button
To cancel the action, press the button
9.
Repeat steps
Description
Switches the function on and off.
Sets up the upper limit for the reactive power which is set as a cos phi (cos φ).
Sets up the upper limit for the active power which is set in per cent of the nominal
power.
Sets up the lower limit for the reactive power which is set as a cos phi (cos φ).
Sets up the lower limit for the active power which is set in per cent of the nominal
power.
The lower limit of the grid voltage range in which the function is active. The param-
eter is used for Italy only.
The upper limit of the grid voltage range in which the function is active. The param-
eter is used for Italy only.
.
ENT
7 to 8 for other parameters if you need to change them.
8 Settings
and to select Mode and
.
ENT
ENT
and
.
ENT
and .
.
ENT
.
ESC
. When
to
77 77