6 Installation
3.
Mount one DC bus bar to connect the DC1+ bar
and the DC2+ bar.
Mount the other DC bus bar with two DC bar
screws to connect the DC1– bar and the DC2–
bar.
4.
Put the cover on the fuse section and screw it
tightly with all six screws.
To ensure protection degree IP65, take care that
–
the cover is correctly positioned and seals the
fuse section,
–
the rubber at the fuse cover is not damaged or
dirty.
44
5.
Fasten the six screws to the fuse section cover.
DC1+
DC2+
DC1-
DC2-
Installation and Operation Manual for RPI M50A