Connecting The Drains - Kodak RP X-OMAT M6B Installation Instructions Manual

Connecting the Drains

The processor is equipped to accommodate the
separation of DEVELOPER, FIXER, and WATER
effluent liquid. The processor is shipped from the
factory with a separate FIXER OVERFLOW/TANK
DRAIN, AUXILIARY FIXER TANK DRAIN,
DEVELOPER OVERFLOW/TANK DRAIN,
AUXILIARY DEVELOPER TANK DRAIN, and a
common WASH WATER OVERFLOW/TANK DRAIN.
To prevent severe corrosion, do not
use brass or copper piping.
[1] Connect the three 1.9 cm ( ⁄
provided, on the FEED-END of the processor.
Route the tubing as required. Drain service
must comply with local codes. Do not make a
solid connection at the floor drain.
246626
3
in.) tubes
4
FIXER
AUXILIARY
DRAIN DEVELOPER
AUXILIARY
DRAIN
FIXER
DRAIN
VALVE
DEVELOPER
OVERFLOW/DRAIN
FIXER
OVERFLOW/DRAIN
Figure 28 Connecting the Drains
DEVELOPER
DRAIN
VALVE
WASH
DRAIN
VALVE
WATER
INLET
WASH
OVERFLOW/DRAIN
H048_0112CCA
H048_0112CA
27