Kodak RP X-OMAT M6B Installation Instructions Manual page 40

If the processor is to be operated at
50 Hz, make sure that the processor is
set for operation at 50 Hz. See the
procedure ''Setting a Processor for
50 Hz Operation'' on page 14.
[12] Move the CIRCUIT BREAKER to the ''I'', or
energized position
[13] Check that the RECIRCULATION PUMPS are
operating by observing motion on the surface
of the solution TANKS.
[14] Allow the wash water to overflow for
5 minutes or longer.
[15] Clean the WASH TANK, if necessary.
[16] Check the processor for leaks.
IMPORTANT
After the processor has been in regular
use for one or 2 days, once again
check the processor for leaks.
40
CIRCUIT
BREAKER
Figure 40 Control Panel of the Processor
H048_0106CCA
H048_0106CA
246626