Kodak RP X-OMAT M6B Installation Instructions Manual page 13

[2] Remove the FEED-END, LOWER ACCESS
PANEL and the 2 SIDE PANELS from the
processor for easier access.
[3] Remove the processor from the SKID.
To prevent damage to the LEVELING
SCREWS and the processor, do not
allow more than a 25 mm (1 in.)
clearance between the bottom of the
processor and the HEAD of the
LEVELING SCREW.
[4] Install the 4 LEVELING SCREWS.
For processors being used on 60 HZ
power, skip the next section on 50 Hz
Operation, and continue with the
section, ''Installing the Light-Tight
Gasket'' on page 17.
246626
NOTE
LEVELING
SCREW
FLOOR
PLATE
Figure 8 Installing the Leveling Screws
2.5 cm (1 in.)
HEAD
H048_0141ACA
H048_0141AC
13