Device maintenance and repair
7.4 Removing and installing hardware components
7.4.8
Replacing the processor
Requirement
● The device is fully disconnected from the mains voltage, see chapter
"Switching off the device (Page 43)".
● The device is open, see the section "Open the device (Page 54)".
● A suitable processor
Only an approved processor is permitted to be installed on the motherboard of the
device. Information about original spare parts for SIMATIC IPCs is available on the
Internet at:
– SIMATIC IPC after-sales information system (http://www.siemens.com/asis)
– Contacts (http://www.siemens.com/automation/partner)
● Manual of the motherboard on the supplied "Documentation and Drivers" DVD.
Procedure
Removal
1. Remove the highlighted fan connector and loosen the four highlighted screws.
2. Remove the heat sink.
82
Operating Instructions, 09/2013, A5E32317120-AA
SIMATIC IPC547E