Table of Contents
Advertisement
8R - 12
WIPERS/WASHERS
HEADLAMP WASHERS - EXPORT (Continued)
STANDARD PROCEDURE - HEADLAMP
WASHER SYSTEM PRIMING - EXPORT
The headlamp washer system may loose it's prime
when the system is serviced. The following procedure
must be used to prime the headlamp washer system.
A DRB III scan tool must be used for this priming
procedure.
Do not allow washer fluid to spray on hot engine
with the hood up.
Do not stand near the headlamp washer nozzles
when actuating the headlamp washer system. The
washer fluid comes out of the nozzles at high pres-
sure.
(1) Connect a DRB III scan tool.
(2) Go to the "BODY" menu.
(3) Go to the "ACTUATER" menu.
(4) Actuate the "HEADLAMP WASHER" actuator
until the headlamp washer system is properly
primed.
Do not actuate the headlamp washers longer that 4
seconds at a time. Allow pump to cool prior to next
attempt. Damage to the headlamp washer pump may
occur.
HEADLAMP WASHER HOSES -
EXPORT
REMOVAL
(1) Open hood and disconnect the negative battery
cable remote terminal from the remote battery post.
(2) Hoist vehicle.
(3) Remove the front fascia. Refer to Body for
Removal procedures.
(4) Disconnect the headlamp washer hoses at the
quick disconnect connectors (Fig. 3) and (Fig. 4).
(5) Remove the headlamp washer hoses from the
radiator closure panel.
INSTALLATION
(1) Install the headlamp washer hoses to the radi-
ator closure panel.
(2) Connect the headlamp washer hoses quick dis-
connect connectors (Fig. 3) and (Fig. 4).
(3) Reinstall the front fascia. Refer to Body for
Installation procedures.
(4) Lower vehicle from hoist.
(5) Refill the washer fluid.
(6) Reconnect the negative battery cable remote
terminal.
Fig. 3 LEFT SIDE HEADLAMP WASHER HOSE
1 - HEADLAMP WASHER HOSE QUICK DISCONNECT
2 - HEADLAMP WASHER HOSE
3 - WINDSHIELD/HEADLAMP WASHER RESERVOIR
Fig. 4 RIGHT SIDE HEADLAMP WASHER HOSE
1 - HEADLAMP WASHER NOZZLE
2 - HEADLAMP WASHER HOSE QUICK DISCONNECT
LH
Advertisement
Chapters
Table of Contents
