Chrysler 300M 2002 Service Manual page 345

8L - 10 LAMPS/LIGHTING - EXTERIOR
FOG LAMP (Continued)
CONDITION
FOG LAMPS DO NOT
ILLUMINATE
REMOVAL
INTREPID/300M
(1) Remove fog lamp housing screw in front fascia
and pull lamp housing from the fascia.
(2) Remove rear cover from fog lamp housing.
(3) Disengage wire clip holding bulb in fog lamp.
(4) Hinge wire clip out of bulb removal path.
(5) Pull bulb from lamp housing (Fig. 11) or (Fig.
12).
(6) Disengage wire connector from fog lamp wire
harness.
Fig. 11 FOG LAMP - INTREPID
1 - FOG LAMP UNIT
2 - REAR COVER
3 - FOG LAMP
CONCORDE
(1) Remove fog lamp housing screw in front fascia
and pull lamp housing from the front fascia.
(2) Disconnect wire connector from fog lamp socket
(Fig. 13).
(3) Rotate socket and pull bulb/socket from lamp
housing.
POSSIBLE CAUSES
1. Blown fuse for fog lamps.
2. No Z1-ground at fog lamps.
3. Faulty fog lamp switch.
4. Broken connector terminal or wire
splice in fog lamp circuit.
5. Broken connection between BCM
and fog lamp relay.
6. Faulty fog lamp relay.
7. Faulty Body Control Module.
1. Replace fuse, refer to Wiring Diagrams.
2. Repair circuit ground, refer to Wiring
Diagrams.
3. Replace headlamp switch.
4. Repair connector terminal or wire splice.
5. Test relay connectors in the Junction
Block and the circuit to BCM. Repair as
necessary.
6. Replace relay.
7. Replace Body Control Module.
Fig. 12 FOG LAMP - 300M
1 - FOG LAMP UNIT
2 - REAR COVER
3 - FOG LAMP
INSTALLATION
INTREPID/300M
CAUTION: Do not touch the glass of halogen bulbs
with fingers or other possibly oily surface, reduced
bulb life will result.
(1) Connect wire connector to fog lamp wire har-
ness.
(2) Cover exposed terminal with teflon coated
sleeve.
(3) Insert bulb into lamp housing.
(4) Hinge wire clip over bulb base.
(5) Engage wire clip to hold bulb in fog lamp.
(6) Install rear cover to fog lamp housing.
(7) Verify fog lamp operation and alignment.
CORRECTION
LH