Operation; Diagnosis And Testing - Front Position Lamp - Export; Removal - Chrysler 300M 2002 Service Manual

LH
FRONT POSITION LAMP - EXPORT (Continued)
Fig. 20 FOG LAMP - 300M
1 - SCREWS
2 - FOG LAMP
Fig. 21 FRONT POSITION LAMP - EXPORT
1 - FRONT POSITION LAMP SOCKET
2 - HEADLAMP MODULE
built in to the headlamp and therefore doesn't
require its own lamp housing.
LAMPS/LIGHTING - EXTERIOR 8L - 13

OPERATION

The front position lamps are turned on or off with
the headlamp switch. These lamps function in the
same way that the parking lamps do on other market
built vehicles. (U.S., Canada). Refer to the appropri-
ate wiring information. The wiring information
includes wiring diagrams, proper wire and connector
repair procedures, details of wire harness routing
and retention, connector pin-out information and
location views for the various wire harness connec-
tors, splices and grounds.
DIAGNOSIS AND TESTING - FRONT POSITION
LAMP - EXPORT
The following test is designed to diagnosis a faulty
front position lamp. Refer to the appropriate wiring
information. The wiring information includes wiring
diagrams, proper wire and connector repair proce-
dures, details of wire harness routing and retention,
connector pin-out information and location views for
the various wire harness connectors, splices and
grounds.
NOTE: Battery must be completely charged (12v)
prior to testing. It may also be necessary to install
battery charger on the vehicles electrical system
when performing this test. Refer to the Battery sec-
tion of the service manual for detailed information.
(1) Remove the front position lamp bulb and check
for burned out condition, replace bulb if necessary.
(2) If bulb appears OK, reinstall the bulb in its
socket and rotate the left side multi-function switch
one detent position and check for lamp operation. If
lamp is still inoperative proceed to step #3.
(3) Remove lamp bulb and check for proper power
(12v) and ground connections in lamp socket. If
power and/or ground connections are not present,
trace wire until open or short is found.

REMOVAL

(1) Remove the headlamp module from the vehicle
(Refer to 8 - ELECTRICAL/LAMPS/LIGHTING -
EXTERIOR/HEADLAMP UNIT - REMOVAL).
(2) Twist and remove the front position lamp
socket from the headlamp module.
(3) Pull the front position lamp bulb straight from
its socket (Fig. 22).