Chrysler 300M 2002 Service Manual page 72

LH
TRAILING ARM/LINK (Continued)
(4) Install wheel and tire assembly on vehicle.
Tighten the wheel mounting stud nuts in proper
sequence until all nuts are torqued to half specifica-
tion. Then repeat the tightening sequence to the full
specified torque of 135 N·m (100 ft. lbs.).
(5) Lower vehicle to the ground.
(6) Tighten the trailing arm to spindle bracket
attaching bolt to a torque of 100 N·m (75 ft. lbs.).
(7) Check and reset rear wheel toe to specifications
if required. Refer to Wheel Alignment.
REAR SUSPENSION 2 - 49