Removal; Installation - Chrysler 300M 2002 Service Manual

8M - 12 MESSAGE SYSTEMS
ELECTRONIC VEHICLE INFO CENTER (Continued)
(3) Upon entering the test mode, the EVIC will
clear the sensor counter and each time a sensor sig-
nal for a road tire is received, the EVIC will update
the counter value (vehicle must be driven at 25 mph
to transmit). The counter values should all read the
same value. If any of the road tires indicate a differ-
ent value than another tire sensor, this is a sign of a
problem. Replace the appropriate tire sensor and
retest the system. This test will continue until any of
the overhead console buttons are pressed or the igni-
tion is turned off.
NOTE: Pressing the RESET button during the test
will sound a beep and reset all the counter values
back to zero.

REMOVAL

(1) Disconnect and isolate the battery negative
cable.
(2) Remove the overhead console from the head-
liner (Refer to 8 - ELECTRICAL/OVERHEAD CON-
SOLE - REMOVAL).
(3) Remove the four screws that secure the Elec-
tronic Vehicle Information Center (EVIC) module to
the overhead console housing (Fig. 8).
Fig. 8 Electronic Vehicle Information Center (EVIC)
1 - Overhead Console Housing
2 - EVIC Module
3 - Illumination Lamps
4 - Screws (4)
Module
(4) Remove the EVIC module from the overhead
console housing.
NOTE: IF THE EVIC MODULE IS BEING REPLACED,
THE TIRE PRESSURE MONITORING SYSTEM MUST
BE PROGRAMMED. REFER TO THE TIRES/WHEELS
SECTION OF THIS
INSTRUCTIONS.

INSTALLATION

(1) Position the EVIC module onto the overhead
console housing.
(2) Install and tighten the four screws that secure
the EVIC module to the overhead console housing.
Tighten the screws to 0.9 N·m (8 in. lbs.).
(3) Install the overhead console onto the headliner
(Refer to 8 - ELECTRICAL/OVERHEAD CONSOLE -
INSTALLATION).
(4) Reconnect the battery negative cable.
NOTE: IF A NEW COMPASS MINI-TRIP COMPUTER
HAS BEEN INSTALLED, THE COMPASS WILL HAVE
TO BE CALIBRATED AND THE VARIANCE SET.
REFER TO COMPASS VARIATION ADJUSTMENT
AND COMPASS CALIBRATION IN THE SERVICE
PROCEDURES SECTION OF THIS GROUP FOR THE
PROCEDURES.
NOTE: IF THE EVIC MODULE IS BEING REPLACED,
THE TIRE PRESSURE MONITORING SYSTEM MUST
BE PROGRAMMED. REFER TO THE TIRES/WHEELS
SECTION OF THIS
INSTRUCTIONS.
NOTE: SOME 300M VEHICLES USE A DIFFERENT
RECOMMENDED TIRE PRESSURE (TIRE SPECI-
FIED). FOR THIS REASON, ANYTIME A EVIC MOD-
ULE IS REMOVED OR REPLACED A DRB III SCAN
TOOL MUST BE USED TO SET/VERIFY THAT THE
CORRECT TIRE PRESSURE SET-POINT IS PRO-
GRAMMED IN THE EVIC MODULE. FAILURE TO DO
SO COULD RESULT IN INCORRECT TIRE PRES-
SURE MONITORING SET POINTS.
MANUAL FOR DETAILED
MANUAL FOR DETAILED
LH