Chrysler 300M 2002 Service Manual page 157

5 - 58 BRAKES - BASE BRAKE SYSTEM
PARKING BRAKE LEVER (Continued)
Fig. 106 Fuse Panel Cover
1 - FUSE PANEL COVER
2 - INSTRUMENT PANEL
Fig. 107 Lower Instrument Panel Cover Mounting
1 - MOUNTING SCREWS
2 - INSTRUMENT PANEL BRACKET
3 - LOWER INSTRUMENT PANEL COVER
(10) Remove the lower instrument panel cover
from the instrument panel. It is attached by retain-
ing clips along the top and right edge.
(11) Remove the wiring harness connector from the
trunk release switch in the lower instrument panel
cover (Fig. 108).
(12) Remove the park brake release cable from the
park brake release handle in the lower instrument
panel cover (Fig. 109).
(13) Remove the 4 bolts mounting the reinforce-
ment to the instrument panel (Fig. 110). Remove the
reinforcement from the instrument panel. Remove
the diagnostic connector from the reinforcement.
Screws
Fig. 108 Trunk Release Wiring
1 - WIRING HARNESS CONNECTOR
2 - TRUNK RELEASE SWITCH
3 - LOWER INSTRUMENT PANEL COVER
Fig. 109 Park Brake Release Cable
1 - PARK BRAKE RELEASE CABLE
2 - PARK BRAKE RELEASE HANDLE
3 - LOWER INSTRUMENT PANEL COVER
(14) Remove the lower A/C duct below the steering
column. It is secured with 1 screw.
(15) Remove the 2 lower mounting screws securing
fuse junction block bracket to instrument panel end
housing (Fig. 111).
(16) Remove the 2 screws securing fuse junction
block upper edge to the instrument panel bracket.
These screws are installed from above the right side
of the fuse junction block and mount to the left.
(17) Remove the dome lamp wiring harness con-
nector from the fuse junction block (Fig. 111).
(18) Move fuse junction block as far down and to
the right as possible without causing damage to the
harness or fuse junction block.
LH