Installation; Park/Turn Signal Lamp Removal - Chrysler 300M 2002 Service Manual

LH
MULTI-FUNCTION SWITCH (Continued)
(3) Install both upper and lower steering column
shrouds. Refer to Body, Instrument Panel, Steering
Column Shrouds, Installation.
(4) Install the tilt lever.
(5) Connect the negative battery cable remote ter-
minal to the remote battery post.
PARK/TURN SIGNAL LAMP
REMOVAL
INTREPID
(1) Open Hood, disconnect and isolate the battery
negative cable.
(2) Remove headlamp.
(3) Rotate and pull socket from lamp housing.
(4) Pull bulb from socket (Fig. 40).
Fig. 40 PARKING, SIDE MARKER, AND TURN
SIGNAL LAMP BULB - INTREPID
1 - BULB
2 - SOCKET
300M
(1) Open Hood, disconnect and isolate the battery
negative cable.
(2) Reach under the fascia and remove the socket
from the lamp housing (Fig. 41).
(3) Rotate and pull socket from lamp housing.
(4) Pull bulb from socket.
CONCORDE
(1) Remove headlamp housing from vehicle.
LAMPS/LIGHTING - EXTERIOR 8L - 31
Fig. 41 PARKING, SIDE MARKER, AND TURN
SIGNAL LAMP BULB - 300M
1 - BULB
2 - SOCKET
(2) Disconnect wire connector from back of lamp
socket(s).
(3) Rotate socket and pull lamp socket from head-
lamp housing.
(4) Remove bulb from lamp socket.

INSTALLATION

INTREPID
(1) Push bulb into socket (Fig. 40).
(2) Install the lamp socket into lamp housing.
(3) Install the lamp housing.
(4) Install the jack screws attaching headlamp to
crossmember.
(5) Connect the negative battery cable and close
hood.
300M
(1) Push bulb into socket (Fig. 41). Rotate socket.
(2) Reach under the fascia and place the socket
into the lamp housing and rotate to lock.
(3) Connect and the battery negative cable and
close hood.
CONCORDE
(1) Push bulb into lamp socket.
(2) Place lamp socket into headlamp housing and
rotate to the lock position.
(3) Connect wire connector to lamp socket(s).
(4) Verify headlamp operation.
(5) Install headlamp housing.
(6) Verify headlamp operation and alignment.