Chrysler 300M 2002 Service Manual page 144

LH
POWER BRAKE BOOSTER (Continued)
Fig. 80 Wiper Module And Cowl Cover
1 - COWL COVER
2 - WIPER MODULE COVER
(5) Remove the 8 bolts, attaching the reinforce-
ment (Fig. 81) to the strut towers and the 1 bolt (Fig.
81) attaching the wiper module to the reinforcement.
Remove the reinforcement from the vehicle.
Fig. 81 Reinforcement Attachment To Vehicle
1 - RIGHT STRUT TOWER
2 - WIPER MODULE
3 - LEFT STRUT TOWER
4 - ATTACHING BOLTS
5 - ATTACHING BOLT
6 - REINFORCEMENT
7 - ATTACHING BOLTS
(6) Disconnect the wire connector from the brake
fluid level sensor on the right side of the master cyl-
inder reservoir.
(7) Remove the 2 nuts (Fig. 82) attaching the mas-
ter cylinder to the vacuum booster.
(8) Carefully slide master cylinder off vacuum
booster with brake lines attached, and position it
backwards, on top of left engine cylinder head cover
(Fig. 83).
(9) Disconnect vacuum hose from power brake
booster check valve. DO NOT REMOVE CHECK
VALVE FROM POWER BRAKE BOOSTER.
(10) From under instrument panel, position a
small screwdriver between the center tang on the
power brake booster input rod to brake pedal pin
retaining clip.
BRAKES - BASE BRAKE SYSTEM 5 - 45
Fig. 82 Master Cylinder Mounting
1 - MASTER CYLINDER MOUNTING NUTS
2 - POWER BRAKE BOOSTER
3 - MASTER CYLINDER
Fig. 83 Master Cylinder Positioning
1 - BOOSTER
2 - MASTER CYLINDER
3 - ENGINE CYLINDER HEAD COVER
(11) Rotate screwdriver enough to allow retainer
clip center tang to pass over end of brake pedal pin
and pull retainer clip off pin. Discard retainer clip
it is not to be reused, replace only with a new
retainer clip.
(12) Remove the four nuts that attach the power
brake booster to the vehicle dash panel. Nuts are
accessible from under the dash panel in the area of
the steering column and pedal bracket.
(13) Rotate the windshield wiper motor crank
lever until the crank lever points in the 12 o'clock
position (Fig. 84).
(14) Slide the power brake booster out of the dash
panel and remove from vehicle.