Chrysler 300M 2002 Service Manual page 217

7 - 38 TRANSMISSION
TRANSMISSION OIL COOLER (Continued)
Fig. 2 TRANSMISSION OIL COOLER
1 - COOLER LINE FITTINGS - 19 N·m (170 in. lbs.)
2 - COOLER RETAINING STRAPS
Inspect external coolers for leaks, loose mounts, or
damage. Replace as necessary.
INSTALLATION
For in-tank transmission oil cooler installation
(Refer to 7 - COOLING/ENGINE/RADIATOR -
INSTALLATION).
For external trans oil cooler installation, perform
the following procedures:
(1) Remove the bolts attaching the A/C condenser
to the radiator (Fig. 3).
(2) Lift A/C condenser up to disengage from upper
retainers on radiator.
Fig. 3 A/C CONDENSER TO RADIATOR
1 - TRANSMISSION OIL COOLER LINE MOUNTING BRACKET
2 - A/C CONDENSER TO RADIATOR MOUNTING SCREWS
(3) Reposition the A/C condenser to allow access to
condenser rear surface.
(4) Remove the previously cut-off cooler retaining
straps.
(5) Position and install the new retaining straps in
the same locations on the condenser.
(6) Reposition A/C condenser on the radiator upper
retainers.
(7) Install the A/C condenser mounting bolts and
tighten to 5 N·m (45 in. lbs.) (Fig. 3).
(8) Install the foam pads on the retaining straps
(9) Position the transmission oil cooler on A/C con-
denser by guiding the retaining straps through the
cooler mounting holes (Fig. 2).
(10) Position the external cooler lines to the side of
radiator. Install support bracket and screw (Fig. 4).
(11) Install the retaining strap locks and tighten to
secure the cooler to the condenser. Trim off the
excess strap material.
Fig. 4 A/C CONDENSER TO RADIATOR
1 - TRANS COOLER LINE BRACKET SCREW
2 - SCREW - CONDENSER TO RADIATOR
3 - TRANS COOLER
4 - SCREW - CONDENSER TO RADIATOR
(12) Connect the cooler hoses to cooler lines and
tighten hose clamps to 3 N·m (28 in. lbs.).
(13) Install radiator side air shields.
(14) Install the front fascia (Refer to 13 - FRAMES
& BUMPERS/BUMPERS/FRONT FASCIA - INSTAL-
LATION).
(15) Install the front wheels
LH