Installation; Wiper Arms; Standard Procedure - Wiper Arm Alignment; Removal - Chrysler 300M 2002 Service Manual

8R - 18 WIPERS/WASHERS
WASHER RESERVOIR FILLER TUBE (Continued)
(3) Remove front fascia as necessary (left side only
and use a 2x4 to prop left edge of fascia away from
body). Refer to Body for Removal.
(4) Reach up behind the washer reservoir and pull
the filler tube off the rear of the reservoir.
(5) Remove one screw attaching washer reservoir
filler tube to upper radiator support (Fig. 11).
(6) Pull filler tube and hose up through left fender
and remove.
Fig. 11 WASHER RESERVOIR FILLER TUBE
1 - SPEED CONTROL SERVO
2 - WASHER RESERVOIR FILLER TUBE

INSTALLATION

(1) Place filler tube in engine compartment and
route through left fender.
(2) INstall the one screw attaching washer reser-
voir filler tube to upper radiator support (Fig. 11).
(3) Reach up behind the washer reservoir and
install the filler tube on the rear of the reservoir.
(4) Install the front fascia as necessary (left side
only and use a 2x4 to prop left edge of fascia away
from body). Refer to Body for Installation.
(5) Lower vehicle off hoist.
(6) Connect the negative battery cable remote ter-
minal to the remote battery post.

WIPER ARMS

STANDARD PROCEDURE - WIPER ARM
ALIGNMENT
The wiper system does not have an indexing fea-
ture designed into the arm and blade assembly. The
arms and blades are positioned to "TIC" marks on
the windshield and secured. This design allows for a
tighter fit between wiper arm and pivot shaft.
(1) Cycle the wiper motor into the PARK position.
CAUTION: After cycling the wipers, turn the wiper
switch and the ignition switch to OFF.
(2) Check drivers side blade tip position is on or
between two "TIC" marks on the windshield. Check
that passenger side blade edge is on or near one
"TIC" mark on windshield.
(3) If requirements are not met, check for and
repair as necessary:
• bent arm or blades
• loose or worn wiper module links
• loose wiper module
• defective module mounting grommets
• defective wiper parking system
• etc.
(4) Position arm and blade to "TIC" marks on
windshield as described above and secure the wiper
arm retaining nuts.
(5) Operate system and verify proper operation. If
problem still exists, refer to Electrical, Wipers and
Washers, Diagnosis and Testing - Wiper System Con-
ditions.

REMOVAL

(1) Cycle the wiper arm/blades into PARK position
and turn ignition OFF.
(2) Using a trim stick (special tool #C-4755) or
equivalent, gently pry up on the wiper arm retaining
nut cap and remove.
(3) Remove the retaining nut from the wiper arm
pivot.
(4) Lift wiper arm to raise blade off glass and
remove the arm from the pivot using a rocking
motion and remove from vehicle.
INSTALLATION
(1) Place the wiper arm on wiper pivot.
(2) Install the retaining nut to the wiper arm
pivot.
(3) Install the wiper arm retaining nut cap.
(4) Cycle the wiper arm/blades to make sure the
arms are positions correctly.
Refer to Electrical, Wipers and Washers, Wiper
Arms, Standard Procedures for adjustments if neces-
sary.
LH