Table of Contents
Advertisement
LH
WASHER HOSES (Continued)
INSTALLATION
(1) Route washer hose up through engine compart-
ment.
(2) Connect washer hose to top of reservoir and to
washer pump discharge port.
(3) Connect hose clips to hood, tower to tower
beam, and fender beam.
(4) Connect right and left hood nozzle hoses at "Y"
connector.
(5) Connect "Y" connector to hood.
(6) install the underhood silencer pad clips along
left rear of hood.
(7) Install the left headlamp unit. Refer to Electri-
cal, Lamps/Lighting - Exterior, Headlamp Unit,
Installation.
Be sure to test and check system for leaks and
pinched or kinked hoses.
WASHER NOZZLE
STANDARD PROCEDURE - WASHER NOZZLE
AIMING
Right and left nozzles have three adjustable spray
juts each.
CAUTION: During adjustment, be careful not to
damage inside opening of jet.
Assure proper ventilation of engine exhaust.
(1) Using a safety pin, adjust each nozzle jet as
required to windshield washer spray pattern.
(2) Each adjustment of the jet should be checked
by actuating the washer system switch from inside of
vehicle.
(3) After adjustment, a final check of the spray
pattern should be done by actuating the washer sys-
tem switch from inside the vehicle with engine
idling.
This model is equipped with two hood mounted
washer nozzles. Each nozzle emits three streams into
the wiper sweep pattern. If nozzle performance is
unsatisfactory they can be adjusted. To adjust it is
recommended to use a safety pin. Insert a safety pin
into the nozzle ball and adjust the spray pattern on
the windshield as shown in (Fig. 7). The right and
left nozzles are identical.
REMOVAL
(1) Using a plastic body filler spreader or equiva-
lent (credit card), gently place it underneath the
front of the washer nozzle. Be careful not to damage
the hood seal underneath the nozzle (Fig. 8).
(2) Rock the nozzle back and forth slightly to
release it from the hood panel.
Fig. 7 WINDSHIELD WASHER SPRAY PATTERN
(3) Pull the nozzle out of the hood panel far
enough to disconnect the hose.
Fig. 8 Windshield Washer Nozzle
1 - HOOD
2 - ADJUST WITH A SAFETY PIN
3 - NOZZLE
INSTALLATION
(1) Connect washer hose and position nozzel over
opening in hood and firmly snap into place (Fig. 8).
After connecting hose, check for proper system
function and to assure leak free connections by actu-
ating the washer system switch from inside of vehi-
cle.
WASHER PUMP MOTOR
REMOVAL
(1) Open hood and disconnect the negative battery
cable remote terminal from the remote battery post.
(2) Hoist vehicle.
(3) Remove front fascia as necessary (left side only
and use a 2x4 to prop left edge of fascia away from
body). Refer to Body for Removal.
WIPERS/WASHERS 8R - 15
Advertisement
Chapters
Table of Contents
