Flash Off Time - Datalogic Gryphon 2D Series Product Reference Manual

References

Flash Off Time

This feature specifies the OFF time for the indicator LED while in Flash Mode.
The selectable range is 100 to 9,900 milliseconds (0.1 to 9.9 seconds), in 100
millisecond increments.
Follow these instructions to set this feature.
1. Determine the desired setting in milliseconds.
2. Divide the desired setting by 100 (setting is in 100ms increments). Pad the
3. Scan the ENTER/EXIT PROGRAMMING MODE bar code to enter Program-
4. Scan the bar code: SELECT FLASH OFF TIME SETTING on
5. Scan the appropriate two digits from the keypad in
NOTE
6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Programming
This completes the procedure. See the table below for examples of how to set
this feature.
Table 21. Flash Off Time Setting Examples
STEP ACTION
1 Desired Setting
Divide by 100 (and pad with
2 leading zeroes to yield two
digits)
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT FLASH OFF TIME SETTING
Scan Two Characters From
5
Appendix D, Keypad
6 Scan ENTER/EXIT PROGRAMMING MODE
298
result with leading zeroes to yield two digits. For example: 0 = 00, 5 = 05,
20 = 20, etc.
ming Mode.
represent the duration which was determined in the steps above. You will
hear a two-beep indication after the last character.
If you make a mistake before the last character, scan the CANCEL bar code
to abort and not save the entry string. You can then start again at the
beginning.
Mode.
EXAMPLES
500ms
05
'0' and '5'
5200ms (5.2
1,000ms (1 sec.)
sec.)
10 52
'1' and '0' '5' and '2'
Gryphon™ I GD/GBT/GM4500
page 117.
Appendix D, Keypad, that
9,900ms (9.9 sec.)
99
'9' and '9'