Intercharacter Delay; Intercharacter Delay - Datalogic Gryphon 2D Series Product Reference Manual

Enter/Exit Programming Mode

Intercharacter Delay

This parameter specifies the intercharacter delay between the end of one char-
acter and the beginning of the next. The delay can be set within a range of zero
(0) to 990 milliseconds in 10ms increments. A setting of zero specifies no
delay. See
ming instructions.
Select Intercharacter Delay Setting
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
46
"Label ID: Pre-loaded Sets"
$CR2IC
00 = No Intercharacter Delay
DEFAULT
on page 288 for more detailed program-
$CR2IC00
Intercharacter Delay = No Delay
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from
the Alphanumeric characters in
pad representing your desired character(s). End by
scanning the ENTER/EXIT bar code again.
CANCEL
Gryphon™ I GD/GBT/GM4500

Intercharacter Delay


Appendix D, Key-
~