Code 128 Length Control; Code 128 Set Length 1 - Datalogic Gryphon 2D Series Product Reference Manual

Enter/Exit Programming Mode

Code 128 Length Control

This feature specifies either variable length decoding or fixed length decoding
for the Code 128 symbology.
Variable Length:
may be set.
Fixed Length:
DEFAULT
$CC8LC01
Code 128 Length Control = Fixed Length

Code 128 Set Length 1

This feature specifies one of the bar code lengths for
on page
page 166
Length includes the bar code's data characters only.
The length can be set from 1 to 80 characters. See
for more detailed programming instructions.
Select Code 128 Set Length 1 Setting
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
166
For variable length decoding, a minimum and maximum length
For fixed length decoding, two different lengths may be set.

166. Length 1 is the minimum label length if in
Mode, or the first fixed length if in
01 = Length 1 is 1 Character
DEFAULT
$CC8LC00
Code 128 Length Control = Variable Length
Code 128 Length Control
Fixed Length on page 166
"Set Length 1"
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from
the Alphanumeric characters in
pad representing your desired character(s). End by
scanning the ENTER/EXIT bar code again.
Gryphon™ I GD/GBT/GM4500
Code 128

Variable Length on
Mode.
on page 302
Appendix D, Key-