Keyboard Interface; Wedge Quiet Interval - Datalogic Gryphon 2D Series Product Reference Manual

References

Keyboard Interface

Wedge Quiet Interval

Specifies the amount of time the scanner looks for keyboard activity before it
breaks the keyboard connection in order to transmit data to host. The range is
from 0 to 990ms in 10ms increments.
NOTE
1. Determine the desired setting in milliseconds.
2. Divide the desired setting by 10 (setting is in 10ms increments). Pad the
3. Go to
4. Scan the bar code: SELECT WEDGE QUIET INTERVAL SETTING on
5. Scan the appropriate two digits from the keypad in
NOTE
6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit.
This completes the procedure to set the Wedge Quiet Interval. See the table
below for examples of how to set this feature.
Table 12. Wedge Quiet Interval Setting Examples
STEP ACTION
1 Desired Setting
Divide by 10 (and pad with
2
leading zeroes)
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT WEDGE QUIET INTERVAL SETTING
Scan Two Characters From
5
Appendix D, Keypad
6 Scan ENTER/EXIT PROGRAMMING MODE
282
This feature applies ONLY to the Keyboard Wedge interface.
result with leading zeroes to yield two digits. For example: 0 = 00, 5 = 05,
20 = 20, etc.
page 82 and scan the ENTER/EXIT PROGRAMMING MODE bar code to
enter Prog. Mode.
represent the duration which was determined in the steps above. You will
hear a two-beep indication after the last character.
If you make a mistake before the last character, scan the CANCEL bar code
to abort and not save the entry string. You can then start again at the
beginning.
EXAMPLES
10ms
01
'0' and '1'
Appendix D,
150ms 600ms
15 60
'1' and '5' '6' and '0'
Gryphon™ I GD/GBT/GM4500
page 82.
Keypad, that
850ms
85
'8' and '5'